Look! Let’s solve the problem of low productivity of EDM wear parts

In the process of EDM processing, we are most worried about the low productivity of EDM wear parts. So, come on! KENOS will relieves your troubles.
In fact, the low productivity of EDM wear parts has many factors. If the low productivity of EDM wear parts occurs in the actual processing, the following two factors can be considered:

1.Due to the limitation of parts structure and clamping, it is impossible to flush high-pressure water effectively. It depends on whether the cutting parts can be improved from clamping. Some parts are affected by supporting fixture, the bottom is raised; some parts are affected by the position of pressure plate and clamping screw, have to raise the upper nozzle; and some operators are afraid of touching the nozzle, did not drop the upper nozzle to the lowest place, the bottom is raised, to see if the clamp can be used to support the same level with the working table surface. For the parts which can not be effectively punched with high pressure water due to the structure limitation, the cutting energy can only be reduced. At this time, we need to have a correct understanding of the cutting efficiency.

2.The cooling water of the EDM filter should be checked if the slow-moving wire feeding system is out of order, because the copper particles will be dropped during cutting process, and the long-term use of the machine tool may lead to the plugging of the EDM filter, which should be cleaned up.
At the same time, the purchase of high quality Wire edm wear parts will also improve productivity.

yize13ka

Above article from KENOS official website:(http://www.edm-accessories.com/)

The original address:(http://www.edm-accessories.com/57.html)